There are many ways to clean a surface, but nothing is as effective as using a pressure washer. A pressure washer is a high-powered machine that uses pressurized water to remove dirt and grime from any surface. It works on the principle lot of high pressure, and you can use different types of cleaning solutions in it depending on your needs.
One such solution is bleach, which is used for cleaning and disinfecting. Many people want to know if they can use bleach in a pressure washer or not.
The idea of using bleach to clean surfaces is not new. Many people even mix it with water and use that solution in pressure washers to clean their driveways and other surfaces. However, this is not a good idea as the chlorine present in bleach can have harmful effects on plants and other natural materials.
The Problem
When bleach mixes with water, it changes into a weak acid called hypochlorous acid. This causes the reactions to take place at a much faster rate than normal. The problem is, chlorine has some negative effects on the environment as well. It is known to be one of the major causes behind water pollution around the world.
Another problem with using bleach in pressure washers is that it tends to break down after getting exposed to sunlight for some time. After prolonged exposure, it loses its strength and becomes toxic for plants and animals. Therefore, you should avoid using such cleaning solutions as they can be very dangerous for your pets and plants at home.
How to Use Bleach Safely?
If you want to use bleach safely, then you need to be very careful about how much you are using in your cleaning solution. The bleach solution is only effective when applied under pressure, and bleach can be corrosive to metal equipment. The temperature of the water also affects how much bleach is released during the cleaning process.
Concentration: 3.5%
Temperature: around 70 degrees Fahrenheit
Pressure: 1000 psi or less
Bleach can damage your pressure washer if it’s not used properly.
- First of all, you should never mix bleach with any other cleaning solutions, as this can cause hazardous gas to be released. You should also keep your body protected by wearing gloves and safety glasses during the process.
- Before applying the solution, make sure that you are standing on a clean surface and that you have an air compressor on hand. This will help to avoid getting any harmful chemicals in the air or on your skin.
- Apply the solution directly onto the stain and let it sit for about ten minutes. Once the time is up, spray water onto the area until it has been completely rinsed off. The best way to do this is to hold the wand over your head and point it down toward the area that needs to be cleaned.
- You can then use a small brush to scrub away any remaining dirt or grime that may be left behind after rinsing off the solution with water. It is important not to try and scrub too hard though because this could cause damage to your deck or other items in the area where you used the bleach solution.
Find much more of these along with the best pressure washer machines at the Giraffetools collections website.
